0,00
PRODUCT TECHNICAL SPECIFICATIONS
Session Area: 615x535 cm
Security Zone: 1015x935 cm
PRODUCT SPARE PARTS
-H: 100 CM STAIR RAILING - 1 PIECE
-METAL STAIR STEP - 5 PIECES
-116X116 CM COMPOSITE PLATFORM - 2 PIECES
-METAL INTERMEDIATE STAIR - 3 PIECES
-POLYETHYLENE SLIDE ENTRANCE - 2 PIECES
-POLYETHYLENE PALM FIGURE - 1 PIECE
-POLYETHYLENE DAISY FIGURE - 1 PIECE
-POLYETHYLENE LANDING BARRIER - 4 PIECES
-METAL SPIRAL EXTENSION - 1 PIECE
/>-METAL SPIRAL SLIDE RAILING - 1 PIECE
-H:100 CM POLYETHYLENE DOUBLE SLIDE - 1 PIECE
-H:150 CM POLYETHYLENE FLAT SLIDE - 1 PIECE
-H:200 CM POLYETHYLENE SPIRAL SLIDE - 1 PIECE
-RAINBOW ROOF - 1 PIECE
-H:100 CM ROOFLESS TOWER PIPE - 4 PIECES
-H:150 CM ROOFED TOWER PIPE - 4 PIECES
POLYETHYLENE PRODUCTS
Low or common density linear polyethylene (LLDPE) is a thermoplastic used in various products.
Semi-permeable, softenable and highly It is a durable polymer and is a highly preferred product in the industry due to its low cost and high resistance. Polyethylene is classified into various categories based on its density and chemical properties.
Its mechanical properties depend on its molecular weight, crystal structure and branching type. Although its properties vary depending on the type; good resistance to external environmental conditions and humidity, flexibility, weak mechanical strength and superior chemical resistance can be counted as general properties. Polyethylene products are used in the production of slides, stairs, railings, barriers, accessories, roofs etc.
In order to prevent color fading in polyethylene products, the ''Light Fastness'' test value of masterbatch paints used to color polyethylene products should be 6 or above.
The product thickness should be minimum 6 mm at points exposed to pressure and friction, and minimum 4 mm in barrier and shade products that are not exposed to any pressure. The material should be distributed equally and create equal thickness. The deviation tolerance of the wall thickness and dimensions of the products is 5%.
ELECTROSTATIC POWDER OVEN PAINT
In order to remove the oil, dirt and rust that will prevent painting on all metal parts, the most effective method is to open the pores on the material with the sandblasting method and make it ready for painting in order to hold the paint better. ,
It will be done by spraying the fine ball material filled in a pressure-resistant cabin with pressurized air to open the pores where the paint will hold and to remove the oil, rust and dirt on the metal material.
After all metal parts are manufactured, they will be coated with polyester-based electrostatic paint and baked in an oven at 200-220 degrees for 20 minutes to complete the painting process.
After all metal parts are manufactured, they will first be rinsed in a 5% concentration degreasing bath at 70 degrees for 10 minutes and then immersed in a 1% concentration iron bath at 50 degrees for 15 minutes.
Then, rinsing and drying processes will be carried out again, the material will be coated with durable polyester-based powder paint for electrostatic system exteriors and baked in ovens at 180-200 degrees for 20-30 minutes to complete the painting process. In order to prevent rust, the entire product will be painted as a single piece after welding.