0,00
PRODUCT SPARE PARTS
-H:100 CM ROOFLESS TOWER PIPE - 8 PCS
-H:200 CM ROOFED TOWER PIPE - 8 PCS
-POLYETHYLENE LANDING BARRIER - 9 PCS
-COMPOSITE LADDER - 2 PCS
-METAL LADDER RAILING - 3 PCS
-POLYETHYLENE LADDER BELT - 8 PCS
-POLYETHYLENE LADDER STEP - 8 PCS
-POLYETHYLENE CLIMBING LADDER - 1 PCS
-POLYETHYLENE FLOWER FIGURE - 1 PCS
-POLYETHYLENE PALM FIGURE - 1 PCS
-RAINBOW ROOF - 1 PIECE
-FLAT BRIDGE - 2 PIECES
-METAL FLAT BRIDGE RAILING - 2 PIECES
-H:200 CM TUBE SPIRAL SLIDE - 1 PIECE
-H:100 CM FLAT SLIDE - 1 PIECE
-H:150 CM HELIX SLIDE - 1 PIECE
-METAL HELIX SLIDE EXTENSION - 1 PIECE
-METAL HELIX SLIDE EXTENSION RAILING - 1 PIECE
-116X116 COMPOSITE SQUARE PLATFORM - 5 PIECES
-INTERMEDIATE STAIR - 1 PIECE
POLYETHYLENE PRODUCTS
Low or common density linear polyethylene (LLDPE-Linear Low Density Polyethylene) is a thermoplastic used in various products.
It is a semi-permeable, softenable and highly durable polymer, and is a highly preferred product in the industry due to its low cost and high resistance. Polyethylene is classified in various categories based on its density and chemical properties.
Its mechanical properties depend on its molecular weight, crystal structure and branching type. Although its properties vary according to the types; good resistance to external environmental conditions and humidity, flexibility, weak mechanical strength and superior chemical resistance can be counted as general properties. Polyethylene products are used in the production of slides, stairs, railings, barriers, accessories, roofs etc.
In order to prevent color fading in polyethylene products, the ''Light Fastness'' test value of the masterbatch paints used to color polyethylene products should be 6 or above.
The product wall thickness should be minimum 6 mm at the points of the material exposed to pressure and friction, and minimum 4 mm in barrier and shade products that are not exposed to any pressure. The material should be distributed equally and should create equal thickness. The deviation tolerance of the wall thickness and dimensions of the products is 5%.
ELECTROSTATIC POWDER OVEN PAINT
In order to remove the oil, dirt and rust that will prevent painting on all metal parts, the most effective method is sandblasting, and the pores on the material will be opened and the paint will be made ready for painting in order to hold better. ,
It will be done by spraying the fine ball material filled in a pressure-resistant cabin with pressurized air to open the pores where the paint will hold and to remove the oil, rust and dirt on the metal material.
After all metal parts are manufactured, they will be coated with polyester-based electrostatic paint and baked in an oven at 200-220 degrees for 20 minutes to complete the painting process.
After all metal parts are manufactured, they will first be rinsed in a 5% concentration degreasing bath at 70 degrees for 10 minutes and then immersed in a 1% concentration iron bath at 50 degrees for 15 minutes.
Then, rinsing and drying processes will be carried out again, the material will be coated with durable polyester-based powder paint for electrostatic system exteriors and baked in ovens at 180-200 degrees for 20-30 minutes to complete the painting process. In order to prevent rust, the entire product will be painted as a single piece after welding.