0,00
PRODUCT SPARE PARTS
-116X116 COMPOSITE TRIANGULAR PLATFORM - 6 PCS
-116X116 COMPOSITE SQUARE PLATFORM - 2 PCS
-COMPOSITE LADDER - 2 PCS
-METAL LADDER RAILING - 2 PCS
-METAL CLIMBING ENTRANCE - 1 PCS
-H:100 CM FLAT SLIDE - 1 PCS
-POLYETHYLENE SLIDE ENTRANCE - 3 PCS
-H:100 CM TUBE SLIDE - 1 PCS
-H:200 CM TUBE SPIRAL SLIDE - 1 PCS
-RAINBOW ROOF - 1 PCS
-POLYETHYLENE PALM FIGURE - 2 PCS
-POLYETHYLENE PLATFORM BARRIER - 7 PCS
-POLYETHYLENE SEAT PANEL - 1 PCS
-H: 100 CM UFO CLIMBING - 1 PCS
-H: 100 ROOFLESS TOWER PIPE - 7 PCS
-H: 200 CM ROOFED TOWER PIPE - 4 PCS
POLYETHYLENE PRODUCTS
Low or common density linear polyethylene (LLDPE) is a thermoplastic used in various products.
It is a semi-permeable, softenable and highly durable polymer, and is a highly preferred product in the industry due to its low cost and high resistance. Polyethylene is classified into various categories based on its density and chemical properties.
Its mechanical properties depend on its molecular weight, crystal structure and branching type. Although its properties vary according to the types; good resistance to external environment conditions and moisture, flexibility, weak mechanical strength and superior chemical resistance can be counted as general properties. Polyethylene products are used in the production of slides, stairs, railings, barriers, accessories, roofs etc.
In order to prevent color fading in polyethylene products, the ''Light Fastness'' test value of masterbatch dyes used to color polyethylene products should be 6 or above.
Product thickness should be minimum 6 mm at points exposed to pressure and friction, and minimum 4 mm in barrier and shade products that are not exposed to any pressure. The material should be distributed evenly and create equal thickness. The deviation tolerance of the wall thickness and dimensions of the products is 5%.
ELECTROSTATIC POWDER OVEN PAINT
In order to clean all metal parts from oil, dirt and rust that will prevent painting, the most effective method is sandblasting to open the pores on the material and make it ready for painting in order to hold the paint better. ,
It will be done by spraying the thin ball material filled into a pressure-resistant cabin with compressed air to open the pores where the paint will hold and to remove the oil, rust and dirt on the metal material.
After all metal parts are manufactured, they will be coated with polyester-based electrostatic paint and baked in an oven at 200-220 degrees for 20 minutes to complete the painting process.
After all metal parts are manufactured,After rinsing in a 5% concentration degreasing bath at 70 degrees for 10 minutes, it will be immersed in a 1% concentration iron bath at 50 degrees for 15 minutes.
Then, rinsing and drying processes will be carried out again, the material will be coated with durable polyester-based powder paint for electrostatic system exteriors and the painting process will be completed by baking in ovens at 180-200 degrees for 20-30 minutes. The entire product will be painted as a single piece after welding to prevent rust on the welded areas.