0,00
PRODUCT SPARE PARTS
-116X116 CM COMPOSITE PLATFORM - 3 PCS
-METAL TRIANGULAR PLATFORM - 6 PCS
-COMPOSITE LADDER - 1 PCS
-METAL LADDER RAILING - 2 PCS
-METAL INTERMEDIATE LADDER - 3 PCS
-POLYETHYLENE LANDING BARRIER - 7 PCS
-H:150 UFO CLIMBING ELEMENT - 1 PCS
-POLYETHYLENE SEAT PANEL - 1 PCS
-POLYETHYLENE SLIDE ENTRANCE - 3 PCS
-RAINBOW ROOF - 1 PCS
-POLYETHYLENE HEXAGONAL LEAF ROOF - 1 PCS
-H:100 CM PLAIN SLIDE - 1 PIECE
-H:150 CM DOUBLE RIGHT INCLINED SLIDE - 1 PIECE
-H:150 CM WAVE SLIDE - 1 PIECE
-H:200 CM SPIRAL SLIDE - 1 PIECE
-METAL SPIRAL SLIDE EXTENSION - 1 PIECE
-METAL SPIRAL SLIDE EXTENSION RAILING - 1 PIECE
-METAL CLIMBING ENTRANCE - 1 PIECE
-POLYETHYLENE CLIMBING LOG - 1 PIECE
-H:100 CM TOWER PIPE WITHOUT ROOF - 6 PIECES
-H:150 CM TOWER PIPE WITH ROOF - 6 PIECES
-H:200 CM WITH ROOF TOWER PIPE - 4 PIECES
POLYETHYLENE PRODUCTS
Low or common density linear polyethylene (LLDPE-Linear Low Density Polyethylene) is a thermoplastic used in various products.
It is a semi-permeable, softenable and highly durable polymer, and is a highly preferred product in the industry due to its low cost and high resistance. Polyethylene is classified in various categories based on its density and chemical properties.
Its mechanical properties depend on its molecular weight, crystal structure and branching type. Although its properties vary according to types; good resistance to external environmental conditions and moisture, flexibility, weak mechanical strength and superior chemical resistance can be listed as its general properties. Polyethylene products are used in the production of slides, stairs, railings, barriers, accessories, roofs, etc.
In order to prevent color fading in polyethylene products, the ''Light Fastness'' test value of masterbatch paints used to color polyethylene products should be 6 or above.
The product wall thickness should be minimum 6 mm at points exposed to pressure and friction, and minimum 4 mm in barrier and shade products that are not exposed to any pressure. The material should be distributed equally and should create equal thickness. The deviation tolerance of the wall thickness and dimensions of the products is 5%.
ELECTROSTATIC POWDER OVEN PAINT
In order to remove oil, dirt and rust that will prevent painting on all metal parts, the pores on the material will be opened with the most effective method of sandblasting and it will be made ready for painting in order to hold the paint better. ,
The thin ball material filled into a pressure-resistant cabin,This will be done by spraying with compressed air to open the pores where the paint will hold and by removing the oil, rust and dirt on the metal material.
After all metal parts are manufactured, they will be coated with polyester-based electrostatic paint and then baked in an oven at 200-220 degrees for 20 minutes to complete the painting process.
After all metal parts are manufactured, they will first be rinsed in a 5% concentration degreasing bath at 70 degrees for 10 minutes and then immersed in a 1% concentration iron bath at 50 degrees for 15 minutes.
Then, rinsing and drying processes will be done again, the material will be coated with durable polyester-based powder paint for electrostatic system exteriors and baked in ovens at 180-200 degrees for 20-30 minutes to complete the painting process. In order to prevent rust, the entire product will be painted as a single piece after welding.